amd on Nostr: Trialing cereal boxes instead of vacuum bags for filament storage. I can’t get any ...

Trialing cereal boxes instead of vacuum bags for filament storage. I can’t get any vacuum bags to hold a seal for more than a couple uses, which makes their cost significantly higher than it would initially seem.

These are a bit higher up front investment ($4 per box, 60g filament, 4 608 bearings, +hygrometers if you’d like) but, if I added the ptfe fitting, I can print from them and they will hopefully last a lot longer.

I’m not in love with this design—it’s a little filament wasteful and not ideal to print—but it works until I design my own.

nprofile1qy2hwumn8ghj7un9d3shjtnddaehgu3wwp6kyqpq2atwfrq4rfv7fqara6gzsgrgj7k8ngewzl5nzs46agwyxzh0e25q6726sn (nprofile…26sn)

#3dprinting #filament