Koz Ross on Nostr: Toolhead time! A few pain points: 1. The kit's wiring is too short for the manual's ...

Toolhead time! A few pain points:

1. The kit's wiring is too short for the manual's arrangement of PE wire and thermal fuse mounting. Swapping them around works, but I wish I knew that _before_ I screwed the bed down.
2. M4 thumb nuts between M3 screws and M3 T-nuts is a level of annoying I didn't think was possible.
3. Formbot labelled their bed cables 'N' and 'L'. How this relates to which cable goes through the thermal fuse, no idea. Can't tell visually either.

npub12atwfrq4rfv7fqara6gzsgrgj7k8ngewzl5nzs46agwyxzh0e25qxlme5y (npub12at…me5y)

#3DPrinting